Quote:
Originally posted by JM317
I just replaced mine in about 10 minutes and it was the first time I've done it. Once the impellar is unscrewed and removed, pull the old seal out with some pliers. Tap the bearing and seal out with a screwdriver or socket. To press the mech seal in, just use a large bench vise and 24mm socket. Place a piece of wood or something behind the back side of the case of course to keep the back from getting damaged by the vise. Place the socket's hollow inner side directly over the edges of the mech seal with the back side of the socket against the other side of the vise. Make sure everything is lined up and even. Crank the vise down. Install the seal and bearing/backside of the impellar seal with another socket (I used a washer inbetween the socket and seal when tapping it), install the impellar again and you're done.