2007 400 fis auto instrument pod

OK here is the issue! Bought the ATV in the fall and it was fine! Over the winter the battery went dead! Ok my fault should have had a trickle charger on it! So any way, it starts up manually runs fine just no instruments indications. This ATV has the fully digital instrument cluster all LED's. So replaced the battery with a new one and the ATV starts and runs fine just NOTHING on the instrument pod just turns red with back lighting! Ok checked the ACC fuse as recommended checked all the fuses checked all the diodes. Check all the connections and looked for corrosion or broken pins. every thing is OK!

So here is the question! Is there any way to reset the the instrument pod?

Any ideas would be helpful!

Mike - :(

Pull the big green 30amp fuse. That seems to "re-set" the gauge. If that fails re-check the connections on the back of the gauge, to ensure it's seated properly.

That's all I gots.......

Hey Thanks for the reply!

I already did that but can't hurt to do it again! Maybe I should make sure there is 12 volts on the back side of the fuse, and just not assume since the fuse is good it must have power!

Thanks for the response!

Mike -:confused:

NP!!