http://i47.tinypic.com/acr4so.jpg
http://i50.tinypic.com/2mg0208.jpg
http://i50.tinypic.com/ojo4so.jpg
Printable View
NICE!
It's been awhile but there has been a 'little' progress.
The main part of the steering linkage is done.
Just need to make the tie rods and the handle bars.
Here are some of the pics of the bell crank for the front section.
http://i44.tinypic.com/5cby2e.jpg
http://i41.tinypic.com/ibz9y8.jpg
As it started.
http://i41.tinypic.com/11h8954.jpg
http://i44.tinypic.com/2emg6xh.jpg
Had to section the support in order to get the bell crank on and off.
http://i43.tinypic.com/1zf0jyd.jpg
http://i39.tinypic.com/bgpo41.jpg
http://i39.tinypic.com/6ftxt5.jpg
http://i41.tinypic.com/15xllyw.jpg
Using oilite for upper and lower thrust bearings and three .750 flat caged roller bearings for lateral movement.
http://i39.tinypic.com/1xxdht.jpg
http://i39.tinypic.com/bdwtvd.jpg
Good progress buddy, keep it up! Hope to see it in the fall?
Awesome fab work!
did this ever get finished?
Not yet.
We moved in December, with all the prep time to move, the move, and all the post move crap I've had no time to work on it.
Plan is this winter to get back on it.