Laeger Swingarm Bearings

I need to replace the swingarm bearings on my Laeger 250R CR500 link swingarm.

Do stock 88/89 bearings server as a good replacement? What about replacing the two chain sliders (small one that goes on the frame and the larger one that goes on the swingarm itself)? Does this use stock 88/89 style or older?

I know that they are discontinued by Honda, so I'm assuming UPP is the way to go.

Lastly the rubber swingarm seals that go on the back where the rear carrier is, what style/year is used there?

Any help or advice would be greatly appreciated.

Thanks!

Stock/aftermarket 88 bearings should be a good replacement fit.

The front chainslider is not the same as an oem but based on 88/89, so any aftermarket labelled for aftermarket (lonestar/laeger will fit. The rear chain slider is a banshee style but again, buying an aftermarket set for aftermarket swingarm will usually fit since they know it's based on banshee style.

The rubber swingarm seals are specific to Laeger (custom), you'd have to call them to get one or find one used.