-
1 Attachment(s)
Hood pins!!! Why not??
So after 10hours or so here's what i came up with....
I machined 1/2" rod stock down to some bullet shaped posts. I then pressed them through my Fullbore mounts with alot of heat and a big hammer.
The pin supports are 1 3/4" washers with a 3/4" center hole that i drilled 4 holes in for mounting. I then polished them and made them look not so "washer" like. I then added a 3/4"O.D. rubber gromet with a 1/2 center hole.
Im not sold on the cable placement yet and will most likely change the cable to some red rubber coated and use some heat shrink plastic over the ferrels.
Now its pull 2 pins, the tank strap and they are off.
Super thanx to my good buddy Ian (Leatherface) for his vision.
-
1 Attachment(s)
more
-
1 Attachment(s)
more
-
1 Attachment(s)
more
-
1 Attachment(s)
more
-
1 Attachment(s)
more
-
1 Attachment(s)
more
-
parts
I like your idea, I think you might have something there that would sell:D , I think I like the look without the cables just my .02
-
-
i agree with skeyrider hoodpins would save alot of time taking the front fender off and look awsome. save like 10 mins no problem