Just wondering if any have the 10" ITP wheels on there 700xx, and if so, can I see a pic of them? Also, how wide is it in the rear with these wheels?
Printable View
Just wondering if any have the 10" ITP wheels on there 700xx, and if so, can I see a pic of them? Also, how wide is it in the rear with these wheels?
ITP say that their 700XX wheel is a +1" offset from stock.
BUT aftermarket 10" tires are also wider than stock so that makes it another inch wider again.......
I think this whole setup is a +2" per side deal.
Linc
I saw that pic on the ITP site, but really didn't get a good rear view. Plus I don't know the width of the rear in stock form, but it sounds like this would make it about 4" wider?
I would agree; I "guess" about 4" wider in total is about right. Notice the wide offset fronts they used just to balance out the pic, if they 4/1's it would look stupid.Quote:
Originally posted by GE4x4
I saw that pic on the ITP site, but really didn't get a good rear view. Plus I don't know the width of the rear in stock form, but it sounds like this would make it about 4" wider?
Linc
I'll take some pics tomorrow with my paddles on.
K?
OK, here's what I found:
Stock width 46 inches.
Width with ITP rims 49 inches.
Here's the pictures:
http://i82.photobucket.com/albums/j2...X/100_9262.jpg
The balloon paddles sure do look skinny. (YES, I KNOW I PUT THEM ON THE WRONG SIDE....THEY WERE ONLY FINGER TIGHT.)
http://i82.photobucket.com/albums/j2...X/100_9267.jpg
Close clearance:
http://i82.photobucket.com/albums/j2...X/100_9265.jpg
http://i82.photobucket.com/albums/j2...X/100_9266.jpg
Also, for what it's worth...
Straight paddles + wider rear = even worse slow speed turning/doughnuts.