Can you put two pieces of body plastic together seamlessly?
I doubt its possible but i'll throw it out there anyhow....I hate the headlight on my 300EX. I was hopin there was some way I could order a 400EX headlight set up and then just cut out a place in the stock 300EX plastic to mount it...the light set up on the 250EX isnt bad either if I could just cut out a place for it and put the two pieces together without a huge nasty seam. So is there something that works like model glue and just kinda melts them together and then i could just use something to sand off the extra and make it smoothe. If not i might see about adding some different lights elsewhere on the quad and just take the stock one off alltogether (and relocate the neutral and reverse lights)