Restored 1985 Honda 250R

This is a 1985 Honda 250R that has been restored from the ground up. Just about everything on this bike is new. Starting from the front...new front tire, new front wheel bearings, new front brake pads, fhreshly rebuilt front forks with new seals and dustcaps, new steering stem bearings, new handlebars, new grips, new front master cylinder, new braided stainless steel front brake line, new petcock seal, new bearings and seals in the motor, new Weisco .080 piston and rings, new Boysen rad valve, recently gone through Keihin PWK 39mm carb., FMF pipe and silencer, new High performance clutch and springs, new front and rear sprockets, new chain, new swingarm bearings, new stainless steel pivot bolt, freshly rebuilt rear shock, new rear axle carrier, new rear brake pads, new Douglas polished aluminum 10" rims with Razor tires, all assembled with a new stainless steel bolt kit....

The entire frame was powdercoated red along with under the seat brackets, the footpegs, rear hubs, and radiator mounts were powdercoated black, both the engine and swingarm skidplates are also powdercoated black, while the swingarm was powdercoated silver. The bike also has new Maier Plastics on it, with a recently restored fuel tank...

http://www.fbodypages.com/joe/3_wheeler/250r_1.jpg

http://www.fbodypages.com/joe/3_wheeler/250r_2.jpg

http://www.fbodypages.com/joe/3_wheeler/250r_3.jpg

http://www.fbodypages.com/joe/3_wheeler/250r_4.jpg

http://www.fbodypages.com/joe/3_wheeler/250r_5.jpg

I have a couple other pictures of how it started out if anyone is interested in seeing how far this bike really came....

Asking $2500 or best offer....

Email @ JoeKreke@aol.com