Bradleys Suspension

Bradley,

What is your ride height set at? I have my rear set at 8" at the footpegs and 8 1/4 at 22 inches in front of the pegs. 22 inches is where the frame is still flat just behind the a-arms.

If you are getting to much roll you might want to lower the height. Just make sure the front is 1/4 inch more then the rear. Measure the height with you on the quad standing on the pegs in ride position.

To raise the height tighten up the pre-load, to lower it loosen the preload.

The compression setting shouldn't affect the roll.

i'll try your suggestion, thanks! i honestly never se them up how i should, i think my rear a-arms bolts are 8.5 off the ground, and the rear is set at 8 inches, which is also the lowest it will go as my rear shock has two preload collars, which i havent seen before or since

compression on the front shocks is 3 from soft. rear is 7 from soft and a cant think of where the rebound is

I ran my fronts about 6 clicks from soft.

If you can't set the rear any lower try lowering the front 1/4 inch.

Make sure you have it measured while you are on the quad.

i love the spongebob figurine on the front of the quad bradley. THats bad ***!lol

i'm ditching spongebob, ive had him on for two races and they have been my worst finishes, i'm pullin' taz out of retirement for the penton