88 Xc 250r

Up for grabs is my 88 XC project...
88 frame= fully gusseted & PCed

Bottom end only (you supply top end)=
Completely rebuilt, every bearing and seal is brand new, aftermarket clutch..this was built from a mint ATC motor that I got on ebay years ago, so it's a short rod with mint tranny.

suspesion= triple rate TCS front & rear set up for a 200 to 250# rider...very little time on these.

A arms= Janseen +1 +1 forward with fresh heim joints.

swing arm= Houser 88 length.

Carb.= 38mm mikuni tmx

pipe= black paul turner ''trx race'' mid range.

stem= +1 chrome houser

Bars= renthal fat bars with billet clamps.

throttle= moose billet thumb throttle

levers= ASV unbreakable.

plastic= white OEM, fronts are in great shape with og. 86 decals and rears are in good shape with a small stiched crack.

reeds= boysen rad valve...needs new reeds.

tires & wheels= powder coated black champion bead locks with 90% hole shot GNCC's.

brakes= brand new rotors and pads, newer calipers front and rear with braided lines.

pegs= roll design non kick ups with PCed black roll heel guards.

axle= brand new RPM +1 with brand new tapered bearings and anti fade.

This has been sitting in my garage for the past 3 years unfinished, all it needs is a top end and a set of reeds and your riding. every bearing, seal brake pad and bushing is brand new with 0 rides.

Looking for $3200.00...quad is located in Morgantown, WV. email works best for me...roby.rollison@gmail.com

http://i4.photobucket.com/albums/y14...250/photo5.jpg
http://i4.photobucket.com/albums/y14...250/photo6.jpg
http://i4.photobucket.com/albums/y14...250/photo7.jpg
http://i4.photobucket.com/albums/y14...250/photo8.jpg
http://i4.photobucket.com/albums/y14.../250/photo.jpg

Throw some offers out there.

1,500.00

Thanks, but I cant go that low.