wat to use to cut m fenders??

[Z400rider24]

Hey just wondering what i should use to cut my fenders??? razorblade, dremel, sheet rock knife??? Let me know asap cause i would like to get them cut this weekend

[member]

i used a hack saw .. but cut an inch away from where you want it then just spend an hour or so sanding it to where you want it.. thats what i did

[JDiablo]

i used a sheetrock knife and a dremel but i didnt like the dremel i couldn't get the lines straight lol....after your done sand off the edges with like 1500 or 2000 grit sand paper and when your done with that go over the edges with a torch or lighter to get the edge back to the normal color but idk if you have to only if you have like red or black plastics,i would still do it though

[EvilJester400EX]

Jigsaw.

[QuAdEr 317]

Jigsaw than finish it up by sanding it to where you want:D

i used a handsaw & marked what i wanted to cut before with a magic marker

[YamaWarr0121]

mark with a dry erase marker and electrical tape or maskin tape and cut with a dremel or jigsaw i prefer a dremel if you have them they ar very easy to work wiht compared to a hand tool or a jig

[Dunesurfer]

The first set I cut I used a grinder, the second I used a jigsaw with a fine tooth blad and it cut them like butter and was easy to control. I put tape where I wanted to cut them off and just followed the edge of the tape line.