atv not starting

[sam the brave]

my warrior does not start it just makes this humming like noise
when i push the start button any ideas on what it could be

[JDiablo]

like a ZZZZZZZZ noise right>?if that is it you got a dead battery

[beak7707]

Sounds like a dead battery to me. Charge it up and make sure all your wire connections are tight.

[hondarider2006]

Dead battery or loose connection. BTW this belongs under the powertrain section....you will get more replys if you start a thread under the right fourm;)

[Cole Trane]

The warriors also have a fuse next to the battery that is notorious for blowing. Check that out.

[chucked]

if all these fail, jump the two large wires on the starter solenoid with a screw driver or something.

my wolverine battery used to die in the winter 2....alls you have to do is..if it make acts like its gonna start for 2 seconds and then goes zzzzzzz turn on the lights and if they dim you have a dead battery

[sam the brave]

it a dead batery the fuse is fine
the hi beams dont work

[chucked]

but the low beams work??

[sam the brave]

but the low beams work??
yes they do but barly

[chucked]

Originally posted by sam the brave
yes they do but barly

if the low beams are working, but barely, but the high beams not working at all, its not the battery, if its not the fuse then theres a bad wire somewhere, Go over all the wires and check for wears, also take off and clean the battery terminals, and frame grounds.