PHAT400
03-04-2004, 10:52 AM
OK, How do I go about this? I checked it out the other day and it appears to be a small brass insert in the carb. Remove the oil tube and it's right there. Do I need to remove the carb (to make the mod easier) and pull, drill, yank, crank or what to get the brass fitting out. Or was it simply meant to be capped.
I'm going to be doing the tranny mod and the the new exhaust. Apparently with the new cdi and these 2 additional mod's this should increase the output greatly. I've been told that the oil injection on the motor does not do well after these mod's. Best to remove it and go to pre/mix.
Oh yeah ;) It's a scrambler 50 03.
:macho
I'm going to be doing the tranny mod and the the new exhaust. Apparently with the new cdi and these 2 additional mod's this should increase the output greatly. I've been told that the oil injection on the motor does not do well after these mod's. Best to remove it and go to pre/mix.
Oh yeah ;) It's a scrambler 50 03.
:macho