300ex handle bars

Do any of you guys know were i could mount the key
holder after you take off that stupid plastic thing. Do you
guys have any pics.

[exriderdude]

you can drill a hole in the side of your plastic and shove it through there. you you can get the plastic thing off of a 250x.

[Scott]

I used zip ties and mounted it pretty much were it was factory, which also happens to be under the crossbar of my renthal bars. It's worked fine for 2 years so far, and the key can't come out with the crossbar pad directly over it.

[dirtclog]

87 250x key holder plastic: about $15

renthal bars (or bars of your choice) about $75

about the best I can do for a picture: Priceless:D

Can you show me a picture from the front
that is kinda hard to see.

[R-Crazy]

here

[cron-ex]

could someone show a pic of the 87 key plastic? I cant see if? I might want to do that, so what all do you have to do? What do you gotta take off the 300 to put the key plastic in??

[exriderdude]

all you do is slip the plastic under your cross bar pad and bolt it on to your light.

[EXrider02]

I have after market handle bars so i had to remove my stock plastiv piece as welll...all i did was took a tie-tie and tied it to another cable..but i would like to here a few other ways of doing it so many it would look neater?

[JB's 400ex]

I have a key holder of a 87 250x. Pretty good shape if anyone is interested. $10 + shipping.

[Live2Ride300]

87' 250X ignition holder-

[Live2Ride300]

it costs around 15 buks, it bolts right on and clips into the front of our headlight perfectly and looks great, u mount your key on the other side-

hey jbs 400ex do you think that would work on a 300ex
do you have a picture of it?

[JB's 400ex]

I don't have a picture of it but I am pretty confident that it would work for a 300. I took the plastic cover from a 300 and put it on my 250. It worked fine, so I would think the 250 plastic would work. It is at my parents house but I could have them send it to you.

["BLAHH"300!!]

get you a 1 inch paddle drill bit and drill a hole in the side of your tank plastic.or where ever you want...if you put it on the side of the tank plastic....make sure there's about 2 1/2 or 3 inches of clearanse behind it for the switch to fit...also put it on the right side..throttle side of your tank..that way you can roll up pull in the clutch and cut off the key with out reaching over your bike...

i made that mistake....also if you want to loose that bulky headlight.....you can drill holes in the side plastic or where ever for the neutral or rever's lights'......this isn't a very good pic but you can see where i mounted mine....ihave sence taken off my light and mounted the rev/nut..lights' beside it.....

can't believe you guys havn't mentiond this yet.....