HELP rear brake wont go over the rotor!

[300EX_HMF]

ok i pushed the piston back as far as it will go, put the pads in there along with the 2 bolts going thought them. now when i go to put them over the Rotor the ride brake pad seems like its to big to go over it. ive tried switching them around, didnt work. i even compared them to my old ones and they look the same.
anyone have any ideas on what the **** is going on??

[300EX_HMF]

anybody??

[Hotdog]

Take your rez. cap off and try pushing the piston back.

[AtvMxRider]

Originally posted by Hotdog
Take your rez. cap off and try pushing the piston back. http://pictureposter.allbrand.nu/pictures/atvmxrider/im20with20stupid.gif

[300EX_HMF]

what piston u talking about? i already pushed that big one back. is there another one i dont know about?

its like the mount where i put the bolts through to keep it on has moved to the right like 1/4 of an inch

[bone705]

is the piston in all the way? to get it in all the way you have to back off your parking brake adjustment.

[440ex kid]

Take a c-clamp and tighten it down over the piston to push it back in.

[exman]

if its the caliper holder thas stopping it, then you can push it back, it will go, if not unlossen it and clean it up.

or take off parking brake , just the cable and little mount and back out that big ole screw in there, then put you clamp on and push the piston the rest of the way.

[Tommy 17]

either theres to much fluid in ur rezzy... take the cap off like they said...


or ur parkin brake is adjusted 2 far in... take it off and put a block of plate on it... and then push the piston in...

[300EX_HMF]

i got er fixed!! i had to unscrew the allen screw on the left side of the caliper to move the mounting bracket.

im prolly comfusing you but dont worry now i got er done