Killswitch install ~ Keyless wiring

[Andy479]

Anyone out there know how to hook up a pro design killswitch and remove the key and wiring?? Thankx in advance to anyone who can help!

[kbass24emtp]

For the kill switch. Take the long wire and connect it to the positive terminal on the coil (its the one with the rubber boot over it). Then take the short wire and ground it to something.
As for the key I don't have a clue.

[quadrcr161]

the key has a plug right under the hood. i just unplugged mine today but now the lights wont work, those are comming off as soon as quadtech releases the hood though. you could trace the wires for the on/off on the handelbars and tap into those.

[2004TRX450R]

connect the black/white wire to one wire on the kill switch and the green wire to the other wire on the kill switch. Then connect the other two wires in the key switch connector to each other and you are done. If you don't connect the other two wires the fan wont work and the carb heater won't work along with any lights.

[Andy479]

thanks 2004trx450r....you rock!

[2004TRX450R]

Originally posted by Andy479
thanks 2004trx450r....you rock! :devil: :devil: :D :D :devil: :devil: