900rracer
02-01-2004, 08:18 PM
I was able to eliminate my on/off switch and relocate the hot start button. I took the parking brake off, and installed the hot start button in place of the parking brake cable. I had to make some "custom" (redneck engineering) mods, but I made it work. I can pull the hot start with my pointer finger just above the clutch lever. Now I can eliminate that boxy on/off switch and headlight switch as well. I race MX so I don't need lights.
I do have a question if anyone knows, the 4 wires that come from the key switch, how do you wire them into a tether switch. I read my shop manual and it looks like you splice the red and black wire together, and use your tether to interrupt the green wire and the black/white wire. Can anyone confirm if this is correct? I have not done it yet. I know the on/off switch uses the green and black/white wires to interrupt. When they are apart (tether switch engaged) the bike runs, when you connect them (pull tether cord off) it shuts down. Any help, I'd appreciate it!
Kevin
I do have a question if anyone knows, the 4 wires that come from the key switch, how do you wire them into a tether switch. I read my shop manual and it looks like you splice the red and black wire together, and use your tether to interrupt the green wire and the black/white wire. Can anyone confirm if this is correct? I have not done it yet. I know the on/off switch uses the green and black/white wires to interrupt. When they are apart (tether switch engaged) the bike runs, when you connect them (pull tether cord off) it shuts down. Any help, I'd appreciate it!
Kevin