AC nerf instalation/pics

[Bubba]

i did some searches but i did not find what i was really looking for. I just got a pair of standard AC nerfs for my 300ex . could someone send some close up pictures of how they mount up and stuff. i just dont want to screw anything up. thanks

[phebus]

AC Racing 400EX 98- 04’
Nerf Bar instructions
Part # 04-4075
Step 1: Check hardware supplied:
(4) 6mm x 35mm bolts
(2) 8mm washers
(2) 8mm x 55mm bolts
(2) 1” spacers
(4) 1/4” spacers
(4) 8mm nylock nuts
(4) 6mm nylock nuts
(4) 6mm washers
Step 2: Remove front lower motor frame-mount bolts. Remove stock bolt
from foot pegs, and heel guards.
Step 3: Place Left side on bike while threading male. Using 8mm x 55mm
bolt from Hardware kit to fasten the front motor mount bolts you will use the
1” spacer here. Use vise grips to hold the nerf in place, and use the holes on
the nerf as pilots to drill through the peg. Then use the 6mm x 35mm bolts to
secure the nerf to the stock foot peg use 1/4” spacer between nerf, and the
fooy peg(inside mount only). Leave bolts loose.
Step 4: Repeat step 3 for other side. Make
sure the male end fits snuggly in the female
end.
Step 5: Tighten all bolts, and weave nets use
illustration as a guide.