300ex/250x Skid plates

[sprtrx300ex]

I'm thinking about making skid plates for Handa 300ex/250x's. They are made out of aluminum with steel supports for extra stength. The metal mounting brackets are welded to the skid.

If I decided to go ahead and start making these, would anybody be interested? How much would you guys be willing to spend?

[redrunner]

Hey what's up. I made a full belly skid for my son's. It worked out pretty good but the bends on a 3/16" (.185) had to be done pretty slow so it did not crack. It will probably take you a few tries but I am sure there is a market for a good quality, lower cost set up. Figure AC's go for $60 on the rear.

good luck!:)