Bars

[300 Hundy]

Whats the best way ya'll bend your bars bac to normal?

[tnine416]

a big metal bar

[ridesa02400EX]

get a torch, heat them up, put a long metal bar over the bent end, stick the bars in between two trees and bend them back with the bar

[AtvMxRider]

Get a new set! When you bend them back it makes them weaker and they will bend alot easier and could break.

i had bent my stockers 4 different times when i had flipped so I bent them back using the bar method...they snapped completely off when I had hit a big jump & landed on flat...it sucked so much

[300 Hundy]

:eek2: that would suck, what kinda bars would you guys recomend for a 300 ex? Cheap but good

[Sportrax10]

Originally posted by 300 Hundy
:eek2: that would suck, what kinda bars would you guys recomend for a 300 ex? Cheap but good
I like my Renthals but they are one the expensive side...

My friend has Moose bars and they seem allright...

[300 Hundy]

will they fit in the stock clamps? and how much did they run

[LazeR]

If i was you i would go with renthal. they may be a lil more expensive but there alot better quality! Mine ran me $60 for my 400ex and yes stock clamps will work with i think any bar but fattys

[300 Hundy]

did u get your off ebay, or the store?

[LazeR]

Originally posted by 300 Hundy
did u get your off ebay, or the store?

I bought from www.rockymountainatv.com you might also check with C&D racing click on the banner on top of the page....I'm not sure if they carry them.....But they do sponsor this site....So try them first