View Full Version : How do I install a rear number plate?
HondaRacing23
01-15-2004, 06:52 AM
I just got a number plate for the rear. Is there any certain way i should bolt it on. Is it not supposed to move or is is supposed to swing back and forth? I was using zip ties on the rear grab bar but i think it looks dumb and sugg?
dirtmomma
01-15-2004, 08:47 AM
Well if your racng you don't want the taillight on the rear to get broke so we just took ours off & use the rubber mounting grommets & zip tye the plate onto thier it works very nice & stays on good no flippin up & down ect.
HondaRacing23
01-15-2004, 08:49 AM
Won the rubber gromates eventualy fall off or do the zip ties hold them on.
dirtmomma
01-15-2004, 08:55 AM
Don't think so, Ron's had his on for a year & half & me for about a year, they've been upside down, rammed into & they're still on :cool:
HondaRacing23
01-15-2004, 08:56 AM
ok ill have to try that. ill have to go get the grommet though. thanks man
HondaRacing23
01-15-2004, 08:58 AM
what do u think of the HMF full system? trying to find me a new airbox lid but knowone has it...
redroost85
01-15-2004, 08:25 PM
I took the tail light out and drilled two holes in the down mounting bars for the light and zip tied my plate in there. Not too snug and not too loose. Works just fine...oh yeah, I should say that my number plate is quite shaved. It is not much bigger than the numbers.:cool:
mxgirl
01-23-2004, 12:11 PM
I welded a couple of tabs onto the back of my grab bar and then used a couple of screws to mount my BRM number plate. I wanted to leave my tail light on for when we ride at night in the dunes (I just unbolt the number plate).
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.