How do I install a rear number plate?

[HondaRacing23]

I just got a number plate for the rear. Is there any certain way i should bolt it on. Is it not supposed to move or is is supposed to swing back and forth? I was using zip ties on the rear grab bar but i think it looks dumb and sugg?

[dirtmomma]

Well if your racng you don't want the taillight on the rear to get broke so we just took ours off & use the rubber mounting grommets & zip tye the plate onto thier it works very nice & stays on good no flippin up & down ect.

[HondaRacing23]

Won the rubber gromates eventualy fall off or do the zip ties hold them on.

[dirtmomma]

Don't think so, Ron's had his on for a year & half & me for about a year, they've been upside down, rammed into & they're still on :cool:

[HondaRacing23]

ok ill have to try that. ill have to go get the grommet though. thanks man

[HondaRacing23]

what do u think of the HMF full system? trying to find me a new airbox lid but knowone has it...

[redroost85]

I took the tail light out and drilled two holes in the down mounting bars for the light and zip tied my plate in there. Not too snug and not too loose. Works just fine...oh yeah, I should say that my number plate is quite shaved. It is not much bigger than the numbers.:cool:

[mxgirl]

I welded a couple of tabs onto the back of my grab bar and then used a couple of screws to mount my BRM number plate. I wanted to leave my tail light on for when we ride at night in the dunes (I just unbolt the number plate).