adrenaline
01-13-2004, 08:15 PM
ight i jetted my carb i couldn't change the fuel screw..does that make a difference..i didnt havwe the right screwdriver but i changed the jet to a 165dj
its pretty cold like 10-30 degrees and at 0 elevation
its says to put the 170 but i put 165 cuz its colder is that right should i ahve gone lower?
also my fuel/air screw is out 2 turns
idle is fine..when moving its got better pull then stock
but in idle if i rev the motor..lets say from closed to about 1/2- 3/4
it just dies...?
should i switch the main jet to a lower number?
ha i kno everyone hates these questions...but too bad :devil:
its pretty cold like 10-30 degrees and at 0 elevation
its says to put the 170 but i put 165 cuz its colder is that right should i ahve gone lower?
also my fuel/air screw is out 2 turns
idle is fine..when moving its got better pull then stock
but in idle if i rev the motor..lets say from closed to about 1/2- 3/4
it just dies...?
should i switch the main jet to a lower number?
ha i kno everyone hates these questions...but too bad :devil: