ECAthumperEX33
01-13-2004, 05:09 AM
I have a 416 motor that was just rebuilt. I was going to run it next year but decieded on doing a yz conversion instead. The following parts have 0 hours on them. New 416 11:1 comp wiseco piston, Hinson Basket/backing plate, factory honda clutch, disk/fibers, new gaskets in the top end, new valves, and seals. The motor has not even been run since the rebuild. It also has the following mods done to it with only around 25hrs on them. TC XC Cam (924?), TC stud kit, side cases powdercoated silver with blue starter cover/oil filter cover, ported intake boot. etc. For the motor i'm asking $1500. I also have the full electrics with an aftermarket starter button that i would throw in with the motor for $1500. I also have a 36mm lectron carb with about 25hrs on it that is set up to run with this motor that i'd also sell as well as a TC rev box that retails for $150. E-mail me at atvmxrider@epix.net if you're interested or have any questions.