torque specs

[Tommy 17]

can u guyz give me the torque specs on the clutches for the 400ex...

i need them for the 5 bolts in this picture

[Silverfox@C&DRacing]

The manual says (not specified) tighten them until they are snug otherwise you may snap one.

[Tommy 17]

ok thanks!!!!

[remlapr]

Tommy - I think I went with around 8, not all that tight and it seems to be working O.K. I have barnett heavy duty springs in mine though so you may want to go just a little more. I wish they would just have a specified number.

[remlapr]

Originally posted by Silverfox@C&DRacing
The manual says (not specified) tighten them until they are snug otherwise you may snap one.

Dusty - could you ask Colby what he usually torques them to and post back. I'm curious to know - thanks.

[Tommy 17]

sounds good remlapr

[Silverfox@C&DRacing]

Originally posted by remlapr
Dusty - could you ask Colby what he usually torques them to and post back. I'm curious to know - thanks.

he tightens them until they are snug with a ratchet (sp?)

[sandspanker]

If you look in the service manual you will find a section in the book that tells you the size of the bolts and what they should be torqued to. At least in the 250r book.I would not go over 80 in.lbs on the pressure plate bolts.

[Hotdog]

dont tighten them to much,they will snap. trust me. Just turn till they stop.

Originally posted by Silverfox@C&DRacing
he tightens them until they are snug with a ratchet (sp?)


Yuuuuuup

[Pappy]

Originally posted by Hotdog
dont tighten them to much,they will snap. trust me. Just turn till they stop.


yup...been there done that:(