View Full Version : exhaust bolts
anyone know what the 4 nuts that hold the the exhaust to the motor need to be torqued to???
There isn't a torque spec in the Clymer manual, just snug them up real good then see if they leak.
Joe
cals400ex
12-30-2003, 12:01 PM
yep, i would just snug them up a bit. however, i wouldn't over do it because it doesn't take much to crush the copper washers for a good seal. also, you don't want to bend the studs that the nut goes on to.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.