***need Help With Axle Instal***

[400extracc]

I have a durablue x-33 axle. When i slid it through the carrier and put on the brake disk hub there is not enough of the spins showing to hook up with the lock nut sleve!?!?! What do I do???
Am i do'n something wrong????!!!

PLS need your help guys

thx!:confused:

[pnut420]

Originally posted by 400extracc
I have a durablue x-33 axle. When i slid it through the carrier and put on the brake disk hub there is not enough of the spins showing to hook up with the lock nut sleve!?!?! What do I do???
Am i do'n something wrong????!!!

PLS need your help guys

thx!:confused:

Make sure you slid it al the way in to where the sprocket hub slides into the carrier, if you still dont have enough room, spin the locknut tight until it pushes the brake hub over enough to expose the thread, then line it up and tighten the lock nut, but dont do it to tight, just snug

[400extracc]

ya, i did that, the sprocket hub will not go any further?????

[400extracc]

pls!!!!!!!!!!!! NEED HELP!!!!!!!!!!

some out there must have installed a durablue X-33 axle with all the stock housing and lock nut!?!?!?!?

thx:(

[AlaskaSpeed]

......the axle goes in the back.........

[400extracc]

back of what????

back of the swingarm

[Chanman420q]

did u put the axle in backwards, try putting it threw the other way

[400extracc]

ok guys, i know how to install the axle!!! it just doesn't seem to fit? i'm asking for help not a smart ***!:mad:

[400extracc]

you can't put it through the other way??? the sprocket hub is there, and doesn't it have to be installed left to right facing the rear of the quad???

i don't think this axle fits the 400ex or the stock housing??

[jgfarmsracer]

have you backed that nut off all the way

if not it will not go on

i've put 4 of these axles in and no problems

did you put new bearings in? if so are they tight together in the housing

[400extracc]

everything is good, the stock axle fits in no problems. the x-33 axle will not slid in far enough. it needs like 1 more inch, but will not go. i tryed taping it in with a malit, but no luck. thebrake hub will fit, but there is not enough room for the lock nut sleve to grab the spindals.

i'm go'n nuts over this?????!!!!!!:mad:

[JOEX]

When I installed my Lonestar axle I had to use a piece of wood and a hammer, pounded it in. the narrow part of the sprocket hug actually goes into the carrier.

Joe

[Aceman]

Why don't you hold your durablue axle up against your stock axle. Then you will know that the distances between the sprocket hub and rotor hub splines are the same distance apart.