View Full Version : canndale axlebearings problem
02 cannon with a lonestar anxle an locknut .rad carrier [taper] can not keep bearings tight help NO ITS NOT MINE:devil:
YLW400
12-06-2003, 10:12 AM
Is the chain overtightened?
NO IT SEEMS LIKE IT NEEDS A SPACER BETWEEN THE HUBS AN BEARINGS
Colby@C&DRacing
12-06-2003, 12:33 PM
The cannondale uses thin spacing washers between the bearing and the sprocket hub. You have to have them in place.:). If they are missing I can get you new one just give me a call. WE are an ATK dealer
i have all spacers in place but with the locknut all the way tight.they are still play in the axle.its like the bearings are not bottom out on the race
Colby@C&DRacing
12-06-2003, 02:07 PM
Man that is weird. I have never had that problem before. How many spacers are you using.
they only sent 1 ribbon washer an thats it its a rad carrier with a lonestar axle if that makes a differ?
Colby@C&DRacing
12-06-2003, 02:16 PM
I guess I should have specified. You have to take the old thin spacing washers out of the stock carrier and install them in the same place in the new carrier. This will fix you problem. They are between the seal and the bearing on the stock carrier there is a couple on each side:) If you have anyother question let me know
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.