propartsracing
12-04-2003, 08:53 PM
This is a serious race engine for sale, it's not a bolt-on kit for a couple hundred dollars. I've listed an LRD price list of the parts that are in it so you know what has been done to it for this price.
$2000 takes it. LOWERED THE PRICE FROM $2700!!!
This engine would cost over $3700 with YOUR OWN engine sent to them. In addition to that the list below, there is also a HINSON Quick Release Clutch Cover, HINSON Billet inner hub. Now, that brings the total up at least another $800 to $4500 if you did it yourself.
JE 13-1 piston - $239.95
sleeve - $120
Gaskets for cam tensioner, exhaust, clt, starter cover, mag cover, center case & kit for hp style head gasket - $79.00
O-rings for intake manifold, mag access cover & oil filter - $7.22
Seals for shift shaft, valve set, counter shaft, oil seal & clutch arm - $41.19
LRD RACE Cam - $175
Valve spring (titatium) $139.95
oil filter - $6
oil - $36
Rocker refinish $260
Stroke $285
Modify Rod (to clear 4th gear) $49
Corillo Rods Kit w/ Rod Bearing and pin $325
8 fiber clutch plate $80
7 thin steel clutch plates $70
Intake valves $80
Exhaust valves $80
Hinson Clutch Basket $225
Shop Supply $10
Gear 19 tooth (shaved) $60
LABOR (install sleeve, bore & torque plate hone, measure and machine V.P. clearance, coat piston, port head Big Valve, Grind valves and seats, Big valve, center case labor, clean seal surface, clt side labor, install clutch basket on clutch gear, labor top end, mag sid labor, resurface cases, rebuild oil pump) - $1,360
$2000 takes it. LOWERED THE PRICE FROM $2700!!!
This engine would cost over $3700 with YOUR OWN engine sent to them. In addition to that the list below, there is also a HINSON Quick Release Clutch Cover, HINSON Billet inner hub. Now, that brings the total up at least another $800 to $4500 if you did it yourself.
JE 13-1 piston - $239.95
sleeve - $120
Gaskets for cam tensioner, exhaust, clt, starter cover, mag cover, center case & kit for hp style head gasket - $79.00
O-rings for intake manifold, mag access cover & oil filter - $7.22
Seals for shift shaft, valve set, counter shaft, oil seal & clutch arm - $41.19
LRD RACE Cam - $175
Valve spring (titatium) $139.95
oil filter - $6
oil - $36
Rocker refinish $260
Stroke $285
Modify Rod (to clear 4th gear) $49
Corillo Rods Kit w/ Rod Bearing and pin $325
8 fiber clutch plate $80
7 thin steel clutch plates $70
Intake valves $80
Exhaust valves $80
Hinson Clutch Basket $225
Shop Supply $10
Gear 19 tooth (shaved) $60
LABOR (install sleeve, bore & torque plate hone, measure and machine V.P. clearance, coat piston, port head Big Valve, Grind valves and seats, Big valve, center case labor, clean seal surface, clt side labor, install clutch basket on clutch gear, labor top end, mag sid labor, resurface cases, rebuild oil pump) - $1,360