Motor Mod Question

[frogburner]

OKAy... With the mods I have listed below,, How much of an increase do you believe I would notice if I were to oversize the valves and port&polish the head???? I have been considering this but dont know yet... I can get port work done on my head for $300 but oversizing the valves,, I dont know yet.... Whats your opinion???

[K_Fulk]

You would probly notice quite a bit since you already have a full pipe and a carb. It will help the air/fuel go through a lot better.

[stupid driver]

you should notice quite a bit of difference. It will broaden your powerband, so you wont have to shift so often. since you Have a high compression piston and cam, you should see some pretty good gains for 300 buks. JMO.