Chanman420q
11-11-2003, 08:02 PM
okay i installed the cam, put it all back together, then hooked up the gas tank and the carb to see if she would run. well she started. i let it ran for a 1min then shut her off. well when i went to start to put everything else back together, i went to slide that bolt threw the frame and the valve cap. It isnt lined up right now :grr: im 99% sure it just slid out when i took it off, but now its not......
also where should i go with jetting. i have no air box lid, no snorkel an FMF slip on and just installed a TC 926 Cam. I have a 155 in there right now, where should i go?
also where should i go with jetting. i have no air box lid, no snorkel an FMF slip on and just installed a TC 926 Cam. I have a 155 in there right now, where should i go?