400ex handle bar on 300ex?

[westcoastmxer]

can u put 400ex renthals on a 300ex?

[nofear911]

Any bars will fit a 300ex, as long as they're no fat bars, then you would have to change the clamps too.
Moose and Fly make a good cheap aftermarket bar too.

[300XFST4602]

I have Renthal 400ex bend on my 300ex and i love it , Alot better than the race bend if you ask me.

[RIDER11X]

Originally posted by westcoastmxer
can u put 400ex renthals on a 300ex?

I had them on my old 250x and loved them!:cool:

[Diedrich]

i got a set of FLY bars on mine and i love em..looks good too

[KASCHAK]

Originally posted by Diedrich
i got a set of FLY bars on mine and i love em..looks good too

fly bars are junk. lol i had them. bent like and s first time it roled. i had on warrior bars 250x bars they all fit. your best off getting renthals. ive seen som pretty brutal crashes. and the stearing stem took more of a beating then the renthals. it was a 30 to 35 rolls down a very very steep hill. it was a raptor. lol

[RIDER11X]

Originally posted by KASCHAK
fly bars are junk. lol i had them. bent like and s first time it roled. i had on warrior bars 250x bars they all fit. your best off getting renthals. ive seen som pretty brutal crashes. and the stearing stem took more of a beating then the renthals. it was a 30 to 35 rolls down a very very steep hill. it was a raptor. lol
I run Pro Taper Pastrana FMX bend bars that are very similar in height to 400ex bars when you add the adaptor clamps. These bars are VERY tough, as most any member here that has ever ridden with me can verify as I am always rolling it over somehow,:o :p with only the need to swap $50 steering stems from the more severe rolls. I have even drilled an access hole in my skid plate so there is no need to waste time taking it off to get to the bottom nut to swap stems!:D :blah: