View Full Version : Cutting Welds On A Stock Header
jasoncarr25
10-14-2003, 08:04 PM
WHAT DOES THIS DO? HOW DO YOU DO IT?
Diedrich
10-14-2003, 09:17 PM
you just grind em off..dont do much i dont think
ridered03
10-14-2003, 09:23 PM
well if you look in side the header pipe there is a raised weld like an inch into the pipe, all you do is take a dremal with a grinding stone on somethin along this line and grind the weld down smooth. After i did this i didnt really notice any difference maybe a little, I mainly did it cause i was boared. but give it a try you might notice slight better throttle response.
I agree with Diedrich and ridered03.....
It is more of a 'I did that' project. I did it myself and even posted a few pictures awhile ago. They didn't turn out that great but if you want to see them do a search of my name and look for somthing like 'ground header welds'.
Joe
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.