wkr triple rate shocks

[MOOCAZEN]

i just got some works triple rate setup for mx 190-210, but dam my bike sits up way higher, and im running +3 a-arms, is there anything i can do to lower it, i was running works b4 setup for baja, so they were reaqlly soft, thnx

[400exRacerX]

You can adjust the preload to a certain extent.

[MOOCAZEN]

how

[400exdad]

You may have to remove the shock to do it. Anyway, pull down the top spring ring and you'll find a "spring clip" in a groove. A pointy screw driver will pry it out on one of its ends. YOU WILL NEED A FRIEND TO HELP HERE. Work it around while the spring ring is down and you can slide it up the shock to another location, hence, reducing the preload on the shock. Do both sides the same and you're done. Just make sure you keep some preload on the sping or they'll be noisy and maybe goob up your shock body by the spring moving around so much when the shocks are extended. If there is too much preload to start off with, you may need a spring compressor.

Good Luck and try not to bust a knuckle!:D