SpeedBump
10-05-2003, 07:08 PM
Well, the engine didn't sell on ebay, so I am going to part it out. Here it is fully assembled. I will tear it down and ship out parts as they are sold. The engine runs, but the valves or guides need to be replaced. Cam fine, BRAND NEW DID timing chain, good clutch basket, polished side cases, polished starter, break in time only on a new .40 over weisco 11.5:1 piston. No leaks, but there has been a repair made to one of the center cases, only a hairline crack, didn't really drip, but made it wet looking. These prices are open for a bit of negotiation. not much, but some. ;)
Polished side cases, left OR right $125 each
polished starter, good shape, $125
cylinder head, no cam/chain, $200(with cam/chain/valvecap-$325)
cylinder/piston/wristpin/clips, $250
clutch assembly $125
complete bottom end/tranny $175
Pics below.
http://users.adelphia.net/~cinnamonlou/pics/300engine.jpg
http://users.adelphia.net/~cinnamonlou/pics/300engine2.jpg
http://users.adelphia.net/~cinnamonlou/pics/300engine3.jpg
http://users.adelphia.net/~cinnamonlou/pics/300engine4.jpg
Thanks
Polished side cases, left OR right $125 each
polished starter, good shape, $125
cylinder head, no cam/chain, $200(with cam/chain/valvecap-$325)
cylinder/piston/wristpin/clips, $250
clutch assembly $125
complete bottom end/tranny $175
Pics below.
http://users.adelphia.net/~cinnamonlou/pics/300engine.jpg
http://users.adelphia.net/~cinnamonlou/pics/300engine2.jpg
http://users.adelphia.net/~cinnamonlou/pics/300engine3.jpg
http://users.adelphia.net/~cinnamonlou/pics/300engine4.jpg
Thanks