Removing lights & key switch...250ex

[RideRed250ex]

How do you remove the Nuetral, reverse lights, and the ignition out of the 250ex?

Thanks

[p@iNn3ck]

Yank them out real quick so it doesn't hurt the quad much......

J/K - do a serach up in the body forum (I think)... theres some good pics and instructions on how to do this and different places to re-mount them.

[RideRed250ex]

I Searched and i can find a lot of stuff about where to mount them and what kinda bars they put but i need to know how you actually remove the ignition, neutral, and reverse lights out of the plastic thing over the handle bars....please help :confused:

[300exOH]

On my 300 I just used a flat screwdriver to pop the colored part off of the reverse/neutral lights and pushed the rubber part through the plastic. I'm not sure about the headlight on the 250ex's but it wasn't hard to do on the 300ex's.

[p@iNn3ck]

Originally posted by 300exOH
On my 300 I just used a flat screwdriver to pop the colored part off of the reverse/neutral lights and pushed the rubber part through the plastic. I'm not sure about the headlight on the 250ex's but it wasn't hard to do on the 300ex's.

Yup! The key switch should have 2 tabs on opposite sides I think. There should be a notch in the hole, you should be able to jiggle it outta there. Or if your not gonna use the plastic part again.... just cut em out!

[RideRed250ex]

THanks