ball joint problems

[Fleshwound]

does anyone have tips on how to get the aarm ball joints out of the spindles??other than beatin the piss outta them...
i know there is a ball joint spreader tool for car, but do they make em in smaller sizes for quads too??
any suggestions would help

u can always use the old standby u can cus at them and then beat the piss outa them make sure u use a rubber hammer or u can use a metal one if u don't want the arms again. :devil:

[Doibugu2]

I just used a big screwdriver. It wasn't that hard.

[400exBro]

pound the chit out of em... is this on your JD's or stockers??

so i am guessing you aren't racing RJ this sunday are you??

[nakomis0]

Theres a really good thread on this in the FAQ forum.

[Fleshwound]

nevermind i got em...haha