nakomis0
08-28-2003, 06:49 PM
This job is a pain in the rear. After beating on it , heating it up and every other dang thing we can think of, for about 1hr the bearing breaks in 12 pieces and leaves the outer race still stuck in the carrier.:confused2 :mad: :grr:
So again we beat and heat, then remember to use the dremel... SoOo another hr. later and its out. Plus we had to grind down all the flaws and scratches that the carrier took in all the abuse.
I replaced bearings before but never like this. Just had to say that is way to hard.
Amd I still gotta go buy and install new bearings, I'm gonna try and throw that carrier in the fridge and see if that helps the install. Feels good to complain on here sometimes.:p
So again we beat and heat, then remember to use the dremel... SoOo another hr. later and its out. Plus we had to grind down all the flaws and scratches that the carrier took in all the abuse.
I replaced bearings before but never like this. Just had to say that is way to hard.
Amd I still gotta go buy and install new bearings, I'm gonna try and throw that carrier in the fridge and see if that helps the install. Feels good to complain on here sometimes.:p