300ex key relocate

[quad_racer_19]

for those who have a 300ex and renthal handlebars who took off the top plastic to show off the crossbar bad...where did you relocate your key?? :ermm:

[jay's 300]

You can use a 250X key holder or like me cut out a hole in the plastic underneath the handlebars on the side about 1". You can also cut a piece of plastic and mount it where your headlight mounts and put your switch there (the way it is on the one I have now) :D

[bradley300]

i wire tied mine to the frame rail directly in front of the motor, just a little above the header.

[sportraxrider10]

you can make on of these..........

http://www.imagestation.com/picture/sraid75/pe70ed1a2c9b436d190dbb3edd6db9a9f/fb51ec83.jpg
http://www.imagestation.com/picture/sraid75/pa16c02b463b149eac0e63f67f441bde5/fb51ebd2.jpg
http://www.imagestation.com/picture/sraid75/p1bc7025c7e27ac80624d3326726ea8b2/fb51ebd6.jpg

[Magicfan25]

http://www.mustangmods.com/data/918/300exside3.jpg

got the hole close to 1" with what we had, used a dremel to get the last little bit out..used a pocket knife to fit the knotch.

[4wheelboy]

Originally posted by Magicfan25
http://www.mustangmods.com/data/918/300exside3.jpg

got the hole close to 1" with what we had, used a dremel to get the last little bit out..used a pocket knife to fit the knotch.


thats how mine is:D

[ZSK]

They're not renthals but it might help, I cut the flaps off of the sides and kept the middle. With the cross bar pad it's tight but I can still get my key in and out, and I can still shut off the machine with out troubles.

http://www.imagestation.com/picture/sraid74/p64be55421ef1b9768f126960c61c6173/fb5fbc7e.jpg

[ny300exrider]

i drilled a one inch hole in the side plastic and stuck it in there. i have a keyholder i can sell from the 87 250x with a crack in one part but will certainly work fine, id sell for like 10 shipped(10 and ill ship it). only reason i need to sell it is itdoenst work with my cr low bars