Need some rebuild help with my 300ex

[SnotMe80]

i have a 98 honda 300ex-i am having trouble with it seems like every other time-it seems to spit and sputter while riding it-if you let off the gas and apply gas again it goes. then say you shut the quad off and go ride again 10 mins. later it runs great-no slugish problems. also i have noticed that if i rev it a little and let off their it blue smoke that comes out the exhaust-i checked the plug and it is fine. i am probalby going to do a rebuild on the motor.-what do i need to get/do for the rebuild. thanks

rob

anything else i should check.

[Diedrich]

for a rebuild just get a new piston, rings, and gaskets. hone the cylinder while you have it apart. also check the cam,rockers, and valves.

[SnotMe80]

what am i looking for on the cam,rockers, and valves. just normal wear or what? how do i know if i need to replace or not.

[dirtmomma]

We're getting ready to order my parts to "freshen" up my 300....it's blowing smoke also so we're going w/ a new piston,rings, seals, you should also have your valves lapped/adjusted. I did a compression test yesterday & it only has 90psi of compression:eek2: :eek: so you could do that too to see where your at, it's supposed to have like 185psi:o
So heck it's gonna run soooo much better after all that heck I thought it ran good now LOL I can't wait to see the difference!!!

[dbsbl1]

Originally posted by SnotMe80

anything else i should check.



Maybe grammar and spelling? :eek2: :D



don

[SnotMe80]

don who needs that on the ex forum?

[dbsbl1]

Bad spelling and grammar??? Nobody does...:eek2: