Magicfan25
08-17-2003, 11:01 AM
I got the Gunner lanyard for my 300EX, looking at a prodesign install the ignition boxes are the same on the 400 and 300ex. My question is, where the Black wire with a yellow stripe goes into the black box under the right fender, can I pull the black wire out of the white plastic connector?
http://www.mustangmods.com/data/918/coil_wire.jpg
For those not familiar with the Gunner Kill switch, it has the ground. Then another wire with two ends on it, one has a rounded metal piece to insert into the clip the factory wire went into. You then insert the factory wire into a crimp style connector also on the gunner switch. Im just nervouse about pulling that factory + coil wire out of the connector there. Thanks guys
http://www.mustangmods.com/data/918/coil_wire.jpg
For those not familiar with the Gunner Kill switch, it has the ground. Then another wire with two ends on it, one has a rounded metal piece to insert into the clip the factory wire went into. You then insert the factory wire into a crimp style connector also on the gunner switch. Im just nervouse about pulling that factory + coil wire out of the connector there. Thanks guys