Want to clean my handle bars up some

[WhiteZee]

i just bought my 2k 300ex a few days ago, so i do not know all the quad terms you all use. i have no parking brake and no light, and i want to remove the parking brake assembly from my handle bars, and i want to get a new "electrical Handle" that only has the starter button and the red off/on/off switch. i ordered the parking brake block for the rear end already. what are my options????

thank you

[deathman53]

you can use a yz or kx kill switch for the starter and for a kill switch, get a tether, get a cr cluth lever to get rid of the stock one. that will clean up the bars really good.

[WhiteZee]

so i can get a yz kill switch and it will take care of the starter, and then i can get a cr clutch lever, and it will remove the parking brake assembly???

[user101]

you have to keep ur stock clutch and perch because of the reverse button...or u can look in the tech section and do the reverse mod.

[muff]

you can get it to look like this (my 400) with the mods that everyone up there told u to do

http://www.imagestation.com/picture/sraid71/p595a4f0221de7630587bd149596ae782/fb94c63b.jpg

go to the tech section and mod the reverse cable, connect the 2 wires that go to the stock perch, get a cr perch and lever, and get a yz kill switch button and wire it in according to this thread I started, it should be very similar to the 300ex

[nismo]

do the reverse mod no matter what it helps a lot!