a-arm setup

[YZEATER]

ok, i'm reassembling my R with new a-arms and shocks and other stuff. the question i have is for the arms and ball joints. on the lower arms do i run the ball joint into the arm as far as it will go and then use the top ball joint for the camber adjustment? what is the right way to set the arms up? i have burgard +2+1 arms if that makes a difference. also what camber do i set it up with? i will be running 20" razr's . thanks.

you should screw the bottom in all the way or its more likely to bend and then use the top one for camber. It may happen that you can not get enough negative camber so u will have to unscrew the bottom one a little bit. You should run about 3 degrees negative camber.