pipe cutting experts

[sportraxrider10]

well i finally am going to cut my pipe. i have been doing wheelys and i fell back and its all messed up. so my question is, on a FMF Power Core 4 how do you cut the pipe, i have all the screws out but nothing on either side will come out? anyone have any advice and even if you can cut this thing?:confused:

[sportraxrider10]

,....

[sportraxrider10]

ddddd

[sportraxrider10]

:confused2

[sportraxrider10]

i don't want to take off too much to make it like 4 inches just enough so it goes behind my grab bar by like 1/2 to 1 inch

[ridered86]

there are rivets holding that end cap on, you can see them, there are prob 4 and go all around the can, you drill those out and remove that end cap, then just cut where you want and re-rivet the end cap back on.

[sportraxrider10]

ok now i have it apart but what do you guys cut it with?

[RIjon]

JigSaw with a metal blade , Chop Saw , or even a hacksaw

[capecod400ex]

I cut mine with a metal chop saw and it came out like this ,

[capecod400ex]

sorry that dident show it well this one dose real good

[sportraxrider10]

capecod, how much did you cut off?


EDIT: nevermidn i see it in your info..duh:o

[capecod400ex]

i think it turned out to be like 5 1/2" but hey :D It dose look lot's better than it did alot of people coment becuase not alot of peep's do this.And ones again its protected.

[sportraxrider10]

is it alot louder than when it was full size?

[capecod400ex]

i couldent tell yea how your's would be but mine was becuase i took the thing the Q pice out when i cut it so it roars now but idk how loud the power core would get i can iamgain not that much louder.

[sportraxrider10]

ok thanks guys. tomorrow my dad is going to take it to this guy that has some kind of cutter, just to make sure the cut is real straight.:macho

[sportraxrider10]

well i got it cut, tell me what you guys think, i took off 2 1/4 inches...


http://www.imagestation.com/picture/sraid71/pd041ed760edeb2c948709614629aaad3/fb9788d4.jpg

[capecod400ex]

looks good is it in past the bar thow:D

[sportraxrider10]

yea just barley, thats the reason why i cut it. i took it straight up on pavement when i had it long and it scrapped the encap all up. so i cut it just enough to make it past the bar. its past like 1/2 maybe?:confused: