Creech52
07-15-2003, 04:29 PM
How do you keep them from backing off, I tightend it tight against the sprocket hub and then tighting the little set screw until I felt I would break the little allen wrench, if you dont know what im talking about its the axle nut that comes with the eliminator 2+2 that doesnt have threads but slips over splines and is held buy a big circlip and you hold the sleeve while you tighten the nut against the hub, its not backing off totally but enough cuz of the clip but its backing off to where the sprocket hub moves back and fourth in a forward direction and im afraid it will wear the splines down. Thnx for any help