air boot connecting from my carb to my engine broke. any suggestions?

[quader400]

well basically what it says up top. the rubber boot that connects to a metal plate wich bolts on the engine broke off. so i used probond to glue it back together. does any one know how much that piece costs. do you think the probond will hold? any input would be great thanks.

[nacs400ex]

www.ronnies.com, they have a parts finder.

[Narly R]

www.UPPracing.com I know they make them for a raptor,banshee, and 250r, but Iam not shure about the 400ex, i think they do andI shure they could make one for you, there GREAT proplr and would give ya a resonable price, it would be around $70!;)

There phone number is 1-800-636-7653 if ya want to give them a call just for the heck of it!:)

[F-16Guy]

I think I'd stay off of it until you get a new one. If the ProBond gives out, it's going to run really lean and hot, and you'll be sucking dirt. It can't cost too much (but then again, it is an ATV part).

[Narly R]

YA, DEFENTLY DONT ride it! It will mess up you air/gas mixture and make ur engine do bad stuuf, and u dont want that!;)

[luvmyex]

They arent too much around 40 i think.I just took one of my buddy's old 400. It only had a few rides on it before the engine said "I QUIT"

[dariusld]

Honda part #16211-hn1-010 Service Honda $23, list price $31

[jerry-89-250R]

is that the first one you have broken? honda changed that part after 99 even the part # was changed, the rubber breaks away from the metal, i think i paid around 28$ 2 years ago for one

[quader400]

well the probond is strong and sealed it good. im going to ride with it one day at the track cause i dont want to miss a day at track. and then ill buy one/

[Martin Blair]

DUCT TAPE TIME

[Scott-300ex]

that happened to my friends warrior and he super glued it to hold it together and to seal it, but that didn't last for long, so just get a new one