Rear Wheel Hubs

[400MXer]

My rear wheel hubs have about 4 wheel studs that just spin. The only way to get the lug nuts off is with an airgun. I am thinking about buying RPM rear wheel hubs. Does anyone have these or have you seen them. What other kinds to you guys have, or know about. Thanks for the info ahead of time!

Purser

[Dave400ex]

Well with all the good things you say about the RPM Axle and other RPM Products you own I don`t think I would buy anything but RPM.

[400MXer]

I know, i pretty much have my mind set on RPM, but i was just askin'. Lookin' for a little feedback.

If i was to buy front hubs though, i would buy baldwin hubs...those are SWEET! but that will be a ways down the road.

RPM makes two style of hubs. Taper lock ones, they have interchangable spline, so you could use 250r hubs on a banshee, or vis versa. But i certainly don't need those. SO, i'm getting their regular wheel hubs. I think they are around $150. but they look nice and will mach my axle well!

[Dave400ex]

Get the RPM Hubs for sure. I would get Baldwin`s Front Hubs too. $150 doesn`t seem that much for RPM.

[dirtclog]

hey..go to ye ol HONDA dealer and ask for part number

90103-ha2-003

these are the wheel studs..chances are you have not damaged the hub just the stud "grooves" that hold it tight...

tap out the old studs and tap in the new...

[400MXer]

already did it, the hub is messed up. In fact, the threads on the wheel stud were fine.

[PhilMoore]

I have DuraBlue rear hubs. They are holding up just fine, and stay tight. They are not pretty, but they are functional and lighter than stock.