clutch levers help [Archive] - ATV Riders Forum

shook

01-13-2002, 05:36 PM

When you change clutch levers and perches what do you with the wires that went to the clutch to keep it from starting in gear do you just leave them alone tape them up or hook them together can anyone give me any suggestions id like it to start without having to put it back in nuetral everytime thanks for the help

NJ300ex

01-13-2002, 05:54 PM

You tape them together. This makes it so you can start in gear even with the clutch out.

01-13-2002, 08:26 PM

yea hook em toghther and make sure they are connected good then tape em up.... works fine!

Stevo

01-13-2002, 10:18 PM

I cut the wires off mine and sautered them together then taped them. It starts without the clutch in now in any gear.

Chef

01-13-2002, 10:45 PM

Just wondering, why would you want to be able to start in any gear without the clutch? my starter has a hard enough time turning just the piston and crank over, but the tranny too?

400MXer

01-14-2002, 02:17 PM

HOTT440EX

i pull in the clutch when i start it. if you don't then your quad will start moving forward.

NJ300ex

01-14-2002, 04:40 PM

we don't want that to happen. Its the only option. If you didn't tape them together you would have to put it in neutral to start it every time you turned it off.

Chef

01-14-2002, 07:31 PM

Originally posted by NJ300ex
we don't want that to happen. Its the only option. If you didn't tape them together you would have to put it in neutral to start it every time you turned it off.

Yea, I hate that, and I dont have any ideas where the wires went from the stock perch, because I didnt put it on.

and 400MXer, I knew that you would pull in the clutch, but I was just wondering why it is such a big deal to be able to start in every gear without the clutch...:huh