Some jetting and other questions

[Kilabanshee]

Well i just got my hotcams stage 2 from hotdog which i would say was an awesome buy and now i need to purchase new jets. Today i went to my local atv shop and they said to run it with the jets i have in now... However i did bye a 162 and a 165 main jet incase it doesnot run clean. What jet would you recomend for my quad with the mods below. Thanks

[cals400ex]

so are you going to use the keihin jets or the dynojets? i would say start with the keihin 165 and go from there.

[Baley69]

I put in a 42 pilot, and a 165 main and it is still to rich. My honda shop said to just try a 160 and leave my needle alone. I'll let you know how it works out.

[YZROOSTINYA]

I run a 155 main and a 45 pilot with needle on the fourth clip.

ALOT of you folks are WAY rich.

Killa- get a XR head gasket and I will do that to with the cam for $50. You need the added compression with that cam.

You should be looking at 152 and 155 main jets

[Kilabanshee]

Ok ill go to cycle center and send my other jets back and ill get the ones you listed. How much does it cost for an xr400 head gasket like 20-30 bones.