Race Cut Fenders

[nastynotchback1]

what is the best tool for cutting stock 400ex fenders.thanks

I used a box cutter and some electical tape...:ermm:

[quadrcr87]

prolly a chainsaw would work best. its gotta be the funnest way!
no i use a jigsaw

[lil400exman]

DREMEL 35,000 rpm cut through it like butta:devil:

[nastynotchback1]

chainsaw was my first thought but i decided to go with rico on the box cutter deal.you used the tape as a guidline right.thanks everyone

[250x#93]

I've thought of doin that, but... I just can't start hackin at it, every time I go to cut it, I decide not to:grr:

[400EXrider#91]

jigsaw. atleast thats what i used

[nastynotchback1]

does a jigsaw leave a jagged edge and what blade do yall use in it.thanks

[quader400]

jigsaw works great and then just sand it down.

i use electrical tape to guid, then cut with a pair of tin snips, then sand down till smooth, then go over it with a torch litley to blend it in

[quader400]

use a dry erase marker to make your lines and follow those.

[Yellow2001400ex]

To smooth out the roughness and bring the full color back, I used a small propane torch. Just run it in a back and forth motion over the edges a few times. Best way that I know how to do it.

[Diedrich]

i used a jigsaw then sanded it down til it was smooth

[QuadJunkies]

I use a Drehmel, then buff it down with a buffer for a drehmel, then propane torch . I didnt even use tape on the last two quads I cut,measured it up perfectly too......:D